Hafele 003.15.061 Titebond III

• APPLICATION GUIDELINES Application temperature: Above 47°F Open assembly time: 8-10 minutes (70°F/50% RH)( Total assembly time: 20-25 minutes (70°F/50% RH) Minimum required spread: Approximately 6 mils or 250 square feet per gallon. Required clamping pressure: Enough to bring joints tightly together (generally, 100-150 psi for softwoods, 125-175 psi for medium woods and 175-250 psi for hardwoods) Methods of application: Plastic bottles for fine applications; glue may also spread with a roller spreader or brush. Cleanup: Damp cloth while glue is wet. Scrape off and sand dried excess. BOND STRENGTH ASTM D-905 (On Hard Maple) Temperature Strength psi % wood failure Room Temperature 4,000 57 150°F Overnight 800 0 LIMITATIONS Not for continuous submersion or for use below the waterline. Not for structural or load bearing applications. Use when temperature, glue and materials are above 45°F. Store product below 75°. Storage above this temperature may cause product to thicken and reduce the usable shelf life. If thickened, shake vigorously by firmly tapping the bottle on a hard a surface until the product is restored to original form. Because of variances in the surfaces of treated lumber, it is a good idea to test for adhesion. For best results gluing exterior doors or exotic and oily woods, please contanct our Technical Support Team at 1-800-347-4583. Read MSDS before use. NOTE: KEEP FROM FREEZING. KEEP OUT OF THE REACH OF CHILDREN
• FDA approved for indirect food contact
• Longer open time
• Lower application temperature
• Resists solvents, heat and mildew
• Safer than traditional waterproof glues
• Sands easily without softening
• Superior strength
• Unaffected by finishes
• Water cleanup & Non-toxic
• Waterproof – Passes ANSI/HPVA Type I Specification

Resources

• Titebond III Ultimate Glue Specifications